中文
English
  - 产品与系统 -
  ·龙牌漆
  ·真石漆
  ·环保涂料
  ·质感涂料
当前位置: 北新涂料 > 质感涂料 >

质感涂料的施工流程

时间:2014-09-17 11:45 作者:Agnes 点击:
1.施工工具:不锈钢灰刀 conshwct tool:stainless steel knife 2.批质感漆前的准备: preparative before slaping the lacquer 检查底漆喷涂、勾缝是否符合要求。 Check priming,spray painting ,pointing which are all up to the mustard or not! 3.批质感

 1.施工工具:不锈钢灰刀

conshwct tool:stainless steel knife

2.批质感漆前的准备:

preparative before slaping the lacquer

      检查底漆喷涂、勾缝是否符合要求。

      Check priming,spray painting ,pointing which are all up to the mustard or

        not!

3.批质感涂料程序及要求:

conshwction flow and requirements

1)用不锈钢灰刀把涂料批到墙上,厚度约3}Smm;

slap the painting to the wall by stainless steel knife

2)批质感涂料的厚度以粗砂粒径大小或稍小为宜,让粗砂稍突出,尽量批平整、均匀。

The thickness of lacquer is down or same the size of open sand grain fine, let open

sand prohwsion a little,smear it smooth and equality

4.注意事项:

attention items

1)施工环境温度不能太高或空气太干燥及风力太大,以免涂料干得太快而对施工有

影响;

construction ambient temperature shouldn't be high or the air is too dry or wind power is

too strong,in case of make the affect for the construction because of the  painting drying so

quickly

2)涂料粘度已合适施工,建议不要再加水兑稀,以免影响涂料性能。

If the viscosity of painting have fit for  the construction ,suggest don't dilute it by water ,in

case of affecting the function of painting

3)施工环境温度大于5 0C,空气湿度小于80%,墙面含水率小于10%

Construction ambient temperature is ups 0C,air humidity is down 80% ,rate of water

网站地图 | 法律声明 | 客户留言 | 网站改版意见反馈联系我们
COPYRIGHT©2008 BNBM ALL RIGHTS RESERVED
更多